GLOSS COATlNGS
back to
PRODUCTS
EVERSEALis a high
performance, water based acrylic sealer, designed to protect and
preserve a variety of porous
clay tile, natural stone and non-glazed
masonry. EVERSEAL dries clear and produces a tough, durable
film, while exhibiting minimal colour enhancement to the surface to
which it is applied. EVERSEAL resists most common household
chemicals and staining caused by food and beverages.
EVERSEAL may be used on
interior, exterior, existing and new floor tile
installations.
RECOMMENDED FOR USE ON:
Porous surfaces with an
absorption rate of 7% or higher, such as Mexican Saltillo clay tile,
cantera stone, rustic limestone, flamed and textured stone, exposed
aggregate, concrete tiles, interlocking pavers, split brick, wire cut
brick (except exterior), grout, rough finished concrete, concrete block,
stucco and similar porous surfaces.
EVERPOLISH is a
highly durable, water base acrylic floor polish, designed to protect and
maintain the finish of newly sealed and existing natural stone, masonry
and clay tile installations. EVERPOLISH is self leveling, self
polishing and produces a deep, high gloss, “wet look” finish without
buffing. EVERPOLISH helps protect floors from the daily wear
and tear of foot traffic and damage caused by scuff marks, marring and
black heel marks. EVERPOLISH is slip resistant and is suitable
for both commercial and residential walking surfaces. EVERPOLISH
exhibits excellent recoatability without excessive build up and can
provide years of lasting beauty and protection when used correctly.
RECOMMENDED FOR USE ON: Floors sealed with EVERSEAL, EVERSEAL200
and EVERBLOCK. Use on sealed Mexican Saltillo clay pavers, epoxy
sealed surfaces, slate, terrazzo, quarry tile, natural stone, flamed and
textured stone, unfinished marble, rough finished granite and most other
non-glazed tiles and composition floors. EVERPOLISH is for use
on interior surfaces only.
back to
PRODUCTS
EVERSEAL200
is a solvent base acrylic specifically designed to seal
and protect a variety of dense natural stone
and clay surfaces.
EVERSEAL200 brightens and enhances the natural colours of the
surfaces to which it is applied, producing a low lustre, satin finish.
EVERSEAL200 helps resist the damaging effects caused by most
common household elements and staining caused by food, beverages and
animal soiling.
RECOMMENDED FOR USE ON:
Tumbled marble, European terracotta pavers, domestic quarry, wire cut
and smooth brick pavers, unfinished granite, quartzite, slate, terrazzo,
travertine, limestone, flagstones, flamed and textured stone, exposed
aggregate and surfaces with similar densities.
EVERSEAL88
is a special blend of acrylic lacquer resins, designed to
protect and preserve a variety of porous clay tile, natural stone and
non-glazed masonry surfaces. SEALER 1088 dries clear and bright,
enhancing the natural colours of the surface to which it is applied,
leaving a deep, rich looking finish. Once fully cured, EVERSEAL 88
leaves a tough, durable film, highly resistant to staining caused by
most common elements. EVERSEAL 88 is suitable for commercial,
residential, interior and exterior applications.
RECOMMENDED FOR USE ON:
Porous surfaces with an absorption rate of 7% or higher,
such as Mexican Saltillo clay tiles, cantera stone, rustic limestone,
exposed aggregate in cement, natural stone, flagstone, unfilled
travertine, wire cut brick, interlocking pavers, concrete tile, rough
and finished concrete.
NOT RECOMMENDED FOR USE ON:
Smooth, dense or impervious surfaces, such as glass,
metal, plastic, glazed ceramic tile, imported and domestic quarry tile,
polished marble, granite or surfaces with similar densities
